What to do if the beard mark is too deep

It is normal for men to have beards, and whether to shave them off depends on each person's aesthetic taste. However, some people, even if they shave every day and shave very cleanly, still have deep beard marks, which look very ugly and cannot be washed away by water. They are very concerned about the solution to this situation. So, what to do if the beard mark is too deep? Let’s take a look at the method below.

There are ways to remove heavy beards, such as laser removal. In addition, freezing point hair removal and E-light hair removal have very obvious improvement and removal effects on beard marks. However, no matter which method you choose, you must do relevant care after removing the beard marks, so as to be responsible for your own health.

How to shave your beard thoroughly

For a more thorough shave, it is recommended to use a manual shaver. Note that it should be used with shaving foam or shaving gel. After washing with facial cleanser, use a hot towel to heat the beard area and keep it for three to five minutes to fully relax the pores and soften the beard. Then use shaving foam or gel to gently apply it to the beard area, gently massage, and fully lather. Then use a razor to shave along the direction of hair growth, with cheeks, sideburns, chin and neck shaved once, then shave against the direction of beard growth once, and finally shave again in the direction of growth to completely shave the beard.

How do men shave correctly?

Foam

If you have beard cream, apply it to the facial areas where you have beard. This will soften the beard and make shaving painless.

electric

If you have an electric shaver, you don't need foam. Instead, before shaving, rub your face with your hands so that the bearded areas feel slightly warm. Then I started preparing to shave.

order

When shaving, remember to shave from left to right, then from top to bottom. Be sure to shave in the order of the beard's growth. In this way, you can shave off the longer beard more cleanly.

clean

After shaving in the forward direction, remember to start shaving in the reverse direction. Shaving in the reverse direction means shaving off the unshaved or short and hard beard in full length.

Nursing

After shaving, remember to soak a towel in hot water, and then gently wipe off the foam or beard on your face. Of course, you can also apply a hot towel to your face more often to relieve the injured beard follicles.

thorough

After the hot compress, check again to see if it is thoroughly cleaned. If not, clean the areas that were not cleaned.