How to wash your face correctly with facial cleanser

Many people do not know how to use facial cleansers correctly, because some may use them incorrectly, resulting in more waste of facial cleansers and poor results. If you want to use facial cleansers correctly, you must first pay attention to the steps. Wet your face with warm water and rinse until foam appears. Do not use force during the process, and massage slowly.

Take a proper amount of water and splash it on your face to moisten it. Take a proper amount of facial cleanser (usually 3 to 5 cm) on the palm of your hand, add water and rub until it forms foam. Apply it on your face and massage for one minute, then rinse it off with clean water.

When using, wet your face first, then squeeze an appropriate amount of facial cleanser on your forehead, nose tip, cheeks, and then on your hands, gently rub it, and then massage your face in circles from bottom to top and from inside to outside for a few minutes. Pay attention to cleaning the T-zone and U-zone where dirt is easily hidden, then rub it with clean water, gently massage for half a minute, and then wash it off.

Step 1: Wet your face with warm water

The temperature of the water you use to wash your face is very important. Some people want to save trouble and wash their faces directly with cold water; some people think they have oily skin and need very hot water to wash off the oil and dirt on their faces. In fact, these are all wrong views. The correct method is to use warm water. This ensures that the pores are fully opened without causing excessive loss of the skin's natural moisturizing oil.

Step 2: Make the cleanser foam fully

No matter what kind of facial cleanser you use, don't use too much, just an area the size of a coin. Before applying to your face, be sure to lather the cleanser thoroughly in the palm of your hand. Most people forget this step, but it is also the most important step. Because if the cleanser does not foam sufficiently, it will not only fail to achieve the cleaning effect, but will also remain in the pores and cause acne. Of course, the more foam the better, and you can also use some tools to make the cleanser foam easily.

Step 3: Gently massage 15 times

After applying the foam on your face, massage in circles gently. Don't apply too much force to avoid causing wrinkles. Massage about 15 times to allow the foam to spread all over the face.

After massaging with cleanser, you can wash it off. Some women are afraid that they can't wash it thoroughly, so they scrub it hard with a towel. This is very bad for delicate skin. You should use a damp towel to gently press on your face. Repeat this process several times to remove the cleanser without damaging your skin.